The Turbo Glue Factory: Boosted Colt Build

[turbomonty]

Feels damn good to have her on springs and not blocks boys!

 

[turbomonty]

Look at that, I made a quad seat for a huge fat bot

 

[turbomonty]

Pretty nice and tight

 

[turbomonty]

Pretty fuking happy with my hack job

 

[turbomonty]

Driver's seat pan done and you can see the cute little drive shaft cage for that monster

 

[Turboyota]

Always stoked for your updates!

 

[turbomonty]

i starred at it for some time this morning until it just started to fall together fairly well

 

[turbomonty]

Got a pair of old mid 80's Ford pumps off Amazon with some awesome cheap china filters and sick billet better not leak and should be better than shit plastic quick fill cap!

also used sendslutsend for the the first time for the Nissan mid 90 240sx caliper brackets for the rear

 

[turbomonty]

GOOD morning
almost as much room as the factory had in the back!
fat shit wont come out. he thinks i will drive off with out him. lol

 

[turbomonty]

Relays and rubber isolators will be here tomorrow for the fuel system in the back

i got 33" x 5' left of my 5x10' sheet to finish off the trans tunnel and fill in the small lady bits in the back

 

[turbomonty]

I need to re drill the jeep rotors so the wheel studs center up better than the .625" holes from China.

Thinking while I'm there, to make these a little more high speed with some extra weight removal! Think they will shatter at speed if I use the brakes????

 

[turbomonty]

Phase 1 of the SEMA rotors is complete

 

[turbomonty]

quick and dirty repeat in the CAM....

 

[turbomonty]

factory weight_________________________ 11 pound 1.8 ounce
stage one ______________________________10 pound 0.1 ounce
final kill mode jegs/summit want-a-bee 9 pound 10.1 ounce

pretty much worth all the time to weaken the shit out of it!

TIR on the rotors are about .025"
i think most of that is in the pressed in studs
the axle flange was about .003"

 

[turbomonty]

cowards wont say there weight!

 

[turbomonty]

Me Standing here imagining how many dudes just drilled there shit in a drill press .....

 

[turbomonty]

Ultralight now

 

[turbomonty]

Got the caliper tack welded in
Looking like some high end O'Reilly shit!

 

[turbomonty]

Got my ARB tank mounted

 

[turbomonty]

ARB wanna be pump and mount