Not much left Tacoma left... 4500 koh build

[Hambone]

Another day of working on this housing…

Started welding out the subframe as well and made the slug for the upper link. Originally it was just a sleeve and then a nut on the end but the bolt was so long, the trans had to come out to pull the upper link. So I made another sleeve and tapped it for a 5/8-18 fine thread bolt. I’ll make a bolt on capture nut plate for the bolt head as well and some red loctite and it shouldn’t go anywhere.

 

[turbomonty]

that is a mountain of good work

 

[Hambone]

that is a mountain of good work

Thanks. Slowly but surely getting there

 

[Hambone]

This was a lot of welding. Same thing. Not the greatest welder when it comes to tube. But getting better already I feel. Front half of the subframe is welded out and to the frame and bump stop cans are in. I think I’m at the point to put the front axle back in and turn it around.