Klever's latest activity
-
NOVEMBER 2024 TIME TO WIRE AND PAINT DESERT T MINUS 12 DAYS I ended up getting a gglighting 12 gang switch panel to run all of my... -
OCTOBER 2024 I have a trip planned for the end of November, im determined to "finish" this thing for then. time to finish my lower...
-
well it has been some time since I've updated my thread; SEPTEMBER 2024, I ended up cutting the rear cross member out to get the spares...
-
Welp... cleaned the garage again... I swear if there is open space in the garage its 100% getting packed with shit... Pulled hood...
-
good thing @Twisted Sid gave me a header... 👀
-
So it begins...3RZ Swap Let me start out by saying I have zero experience with anything motor related other than timing chain, valve...
-
I've been cranking out quite a few jobs the last few weeks, between rebuilding parts of the sand demon, caging RadoNoah's Silverado, and...
-
Didn't do much this weekend, other than clean the shop up.
-
i took 2 pictures of the mess i sort of made/cleaned up yesterday................. that's something, RYT?!?!?!
-
-
Front clip is painted shifter is in rear drive shaft is measured cut and remade just waiting on new u joints. Rear bypasses finally...
-
2005 toyota tundra 4x4 long travel. Front End, Complete MCM fab LT kit with ADS 2.5 C/O and 2.5 trip Bypasses with 2.0 air bumps, 300M...
-
Klever reacted to Exploder_M's post in the thread Short Course Style mid mud flaps/rock guards? with
Like.
I run these EPDM rubber shock guards. They can be cut to shape and are secured using quality removable zip ties. They were a last minute... -
Done!!
-
Put a 1970s Maserati motor in pretty decent 304 frame i built in a couple days all hand cut stuff as i dont have a table or hell even a...
