Baconcreekmetal's latest activity
-
BYou didn't mention anything about the quarter elliptical leafs. What's your reasoning for adding those as opposed to just a heavier...
-
BI’m sure you smart enough to cycle everything in real person before you welder up. While scanning and cad have come a tremendous amount...
-
BThis whole bean setup and steering was built by ohhchofab probably 10 years ago? It went up for sale and I had to snag it I've had it...
-
BBeen a while since I've posted but the bronco is going under the knife for some much needed upgrades. Here are some photos.
-
BBaconcreekmetal replied to the thread THE NUCLEAR UNICORN.It's looking great.
-
BI got my diff skid from Autofab for my ranger. Worth every penny.
-
BI've had small amounts of oil out of the valve cover breather and drips on the headers, we did a catch can if you run into the same issue.
-
BA few more weekend updates.. Installed the new valve covers and added some flare to the center console panel. I'm going to start on the...
-
BA few updates... My good buddy Robert Moruzzi hooked me up with a set of his valve covers for Christmas, to compliment the motor he...
-
BThank you! When its prep time, the radius arm and beam come off normally. I cap the the line at the frame and pull everything off. Being...
-
BPlumbing the brakes was one of my favorite jobs when I built my truck. The right tools makes it much more enjoyable
-
BVery nice I'v been putting that job off. I have a donkey dick like 20" braided line from the frame to caliper lol.
-
BUpdate... Began building the brake lines from the frame to the knuckles.
-
BSome front end TLC after noticing my radius arms / diff guard were getting rusty from all the gouges Grind down and fresh coat of AA...
