Baconcreekmetal's latest activity
-
BUpdate on the truck from Daniel killing it on the truck. Had to ditch the brake booster and going to a full manual set up, Daniel is...
-
BDrivers side done. Time to pull everything apart, get the last few things welded, and paint! Intake and filter done. Spectre inline...
-
BFull bump, centered in the wheel well, tire has probably around 6 inches turning radius both directions. I could probably push it...
-
BPicked up the beams from the welder today. DIY offroad kit went together pretty smooth I didn’t use all the plates and did a different...
-
BLeft side mocked up and cycled Roughly 8.5” uptravel, 16” overall, 10° caster at ride height, radius arms are dead flat at ride height...
-
BAnybody know if its possible to bend 2” .250 wall tube? The radius arm hits the unibody before full bump. Putting a slight bend in it...
-
BThe DIY dana 44 plates fit up good. I cut a set out and used about 3/4 of the plates in the kit. I did 2" wider beams so I modified the...
-
BMaking progress!! Crossmember pre painted for black alloy armor. Will get final layer once installed and welded Frame stiffeners and...
-
BAlso pretty stoked to find out that my d44 diff has the c-clip eliminator already!
-
BTook it out for one last rip as with a solid axle front end then pulled into the garage to hibernate New Outlaws vs the old ones. The...
-
BWhats everyone’s preferred D44 plate/overlay kit? Leaning towards the DIY offroad
-
BNow that I've decided to keep it, I'm fully locked in on building it exactly how I want it. Ever since I bought a 1st gen Explorer 2...
-
BThe poor D30 really got put through the paces haha. Thought I bent the C's a couple times but never did. So in April 2025 I was dead...
-
BAfter a year-long battle with myself on whether or not to keep this Cherokee, I've decided to keep it and build it so its time to catch...
