The Turbo Glue Factory: Boosted Colt Build

[turbomonty]

Not going to chop suey on this thing. It just needs to lay square to the 2" tubing

 

[turbomonty]

Dimples the power steering resi with some stuff laying about

 

[turbomonty]

So glad the alternator and power steering pump are done
Now just some idler pulley's to add in there

 

[turbomonty]

Power steering resivour done

 

[turbomonty]

Idler pulleys

 

[BobbyHasARustyBronco]

Is this real time? How much youve accomplished so quickly is impressive!

 

[turbomonty]

i just have about 4-8 hours a weekend

 

[turbomonty]

Chucked up the front rotors in the lathe and had chatbot write a macro to turn off some mass
dropped 2 pounds off. the pads only ride on so much of what it had there...

 

[turbomonty]

Time to finish up some welds

 

[turbomonty]

Time to fight the final boss in fabrication
Main center link and then baby tie rods to the knuckles

 

[turbomonty]

Bent up the last piece of sheet
wraps tight on the drive shaft loop on the rear
a couple 1/4" screws hold the bottom of both sides down on the floor flange
the front will get stitched up and the whole thing glued once it is time