The Turbo Glue Factory: Boosted Colt Build

[turbomonty]

after a day and a halve of madness i got a steering tie rod solution that is pretty good. set up a laser on the rotor, scribed a plumb line on some cardboard with check marks of bump, ride and droop.
~1/8" toe in at bump and ~1/4" toe out at droop.

https://www.youtube.com/watch?v=CzWRoED6xdo

 

[turbomonty]

ok got my display working with my EFI controller. i can toggle through the pages.
one for fuel, spark and a home page.
spark is in degrees and fuel is in raw micro seconds of discharge.
all live to read and write at any time on the EEPROM

https://www.youtube.com/shorts/F1ywD2GVm_Y

 

[smokeysevin]

I found these combo temp/pressure sensors the other day and am trying them out for coolant temp/pressure and oil temp/pressure. Not sure when I will get them fully done but they are pretty slick and the curve is way better than the lowdoller-motorsports ones I tried before.

Sean

 

[turbomonty]

very cool piece
what is the cost?

 

[smokeysevin]

Mouser has them for $50 each.

https://www.mouser.com/ProductDetail/Amphenol-Advanced-Sensors/GE-2099?qs=Li%2BoUPsLEnvwWzv5ZH2jug==

The lowdoller-motorsports ones didn't play nice with my megasquirt and were more expensive.

https://lowdoller-motorsports.com/p...mbo-300-psi-500-f?_pos=1&_sid=a86321b35&_ss=r

Sean