The Turbo Glue Factory: Boosted Colt Build

First tube
Rear bumper with two chop saw wedges cut so it follows contour some
 

Attachments

  • IMG_20250726_080100031_HDR.jpg
    IMG_20250726_080100031_HDR.jpg
    1.7 MB · Views: 33
  • IMG_20250726_080108815_HDR.jpg
    IMG_20250726_080108815_HDR.jpg
    1.9 MB · Views: 22
Second bar is grabbing both side of the rear fenders
 

Attachments

  • IMG_20250726_111740307.jpg
    IMG_20250726_111740307.jpg
    3 MB · Views: 11
  • IMG_20250726_111746703_HDR.jpg
    IMG_20250726_111746703_HDR.jpg
    2.5 MB · Views: 7
  • IMG_20250726_112020788_HDR.jpg
    IMG_20250726_112020788_HDR.jpg
    1.7 MB · Views: 9
  • IMG_20250726_112039734.jpg
    IMG_20250726_112039734.jpg
    2.2 MB · Views: 11
Softened up the bumper ends with a 45 tip
Got two tubes squaring up the back
Time to make fuel tank bottom straps and mount it
Need to get shitty car battery for way too much money at lunch too
 

Attachments

  • IMG_20250726_124336620.jpg
    IMG_20250726_124336620.jpg
    1.9 MB · Views: 12
  • IMG_20250726_124330205.jpg
    IMG_20250726_124330205.jpg
    1.8 MB · Views: 10
  • IMG_20250726_124322639.jpg
    IMG_20250726_124322639.jpg
    1.6 MB · Views: 10
Little section done
5 body mounts
It will support itself in position now
 

Attachments

  • IMG_20250726_194632284_HDR.jpg
    IMG_20250726_194632284_HDR.jpg
    1.9 MB · Views: 6
  • IMG_20250726_194645212_HDR.jpg
    IMG_20250726_194645212_HDR.jpg
    1.9 MB · Views: 8
Finally got freed up to waste more time and money on this.
2" square tube floor parameter and later I will bend a hoop to clear for the driver shaft
 

Attachments

  • IMG_20250727_165710316.jpg
    IMG_20250727_165710316.jpg
    2.5 MB · Views: 15
  • IMG_20250727_165702349_HDR.jpg
    IMG_20250727_165702349_HDR.jpg
    2.2 MB · Views: 9
Back
Top