Stock D44 TTB Measurement?

[troysladeck]

Just bought some Threat 4.5” extended beams and planning on cutting them down back to stock length and welding a uniball on the end. Does anyone have some stock d44’s laying around that could get me some measurements?

Looking for length from the top ball joint to pivot as accurately as possible. I know they are around 37” / 29” but trying to get them perfect.

Also looking for width of the pivot bushing so I know what size unibal cup / misalignments to get.

Thanks!

 

[Giant Geoff]

Just bought some Threat 4.5” extended beams and planning on cutting them down back to stock length and welding a uniball on the end. Does anyone have some stock d44’s laying around that could get me some measurements?

Looking for length from the top ball joint to pivot as accurately as possible. I know they are around 37” / 29” but trying to get them perfect.

Also looking for width of the pivot bushing so I know what size unibal cup / misalignments to get.

Thanks!
View attachment 45218

If you cut them down to be stock with the Radius Arm will hit the Beam pivot and not work.
.

 

[troysladeck]

If you cut them down to be stock with the Radius Arm will hit the Beam pivot and not work.
.

Are you talking about the beams being too wide to fit into the pivot mounts? If so, yes I figured I would have to narrow them about an inch at the ends to match the width of the uniball cups