1980 toyota pick up new build

[Banging_limiter]

Since I don’t have the time or funds to finish my 4runner I got a 2wd pick up I’m about to swap everything over to wheel for this and maybe next season. I’ll post updates as it gets done. Also I plan on selling the thing eventually when the 4Runners done.
Parts list
-taco width rock assaults
-3rz
-w56 and dual cases 2.28 front 4.7 rear
-rears up front and Chevy 63s
-150’ of 1 3/4” DOM tubing

 

[Turboyota]

Oh my fucking god I hope you can keep those wheels!

 

[Banging_limiter]

Oh my fucking god I hope you can keep those wheels!

If they were 6 lug I’d run the shit out of them

 

[Banging_limiter]

First things first pulled a spring from the ruf pack that was on the runner they work good but I’m trying to keep this thing as low as I can and cut a lot of the fenders and body off it I need to. I was going to French the hangers but I’m lazy and have a lot to get done in a short amount of time.

The anti wrap leaf on top is great idea broke a lot of spring packs before I found that out.

 

[Turboyota]

If they were 6 lug I’d run the shit out of them

Don’t worry, eGay has what you fucking NEED

 

[Banging_limiter]

Got the motor and trans out and most of the front end stuff off time to start cleaning the frame and Sas it. Anyone ever run stock rears in the back reversed? I was gonna put 63’s but I kinda don’t like how far back the shackle hangers are I’m gonna build a bed and want this thing to not be a boat.

 

[Banging_limiter]

I will of course add some leafs to the pack but I think I’m gonna try it.

 

[badlinesgoodtimes]

oh hell yea brother!

 

[Banging_limiter]

oh hell yea brother!

Gonna have to do some wheeling soon!!! Should have it ready to go by thanksgiving.

 

[Banging_limiter]

Got all the ifs junk cut off and the rear axle pulled all the dash and wiring ripped out going to mount the front and rear axles tomorrow I had to notch a lot of the body mounts out to get the front hanger where I wanted it and the right distance to mount the shackles. But I’m gonna do boat sides and weld the cab to them anyways so not a big deal.

 

[Banging_limiter]

Didn’t get anything done today really but I did build the rear spring packs and hung the rear axle in place I had some problems with eyes of the rear springs being pretty clapped with the new bushings so I squished them in the press and let them sit for a few and it ended up closing the eye enough for the bushing to be a tight fit.

For anyone wondering it’s about the time you should leave them in, it’s about the time it takes to smoke an American spirit and drink a beer. pull them any sooner and the holes still clapped.

 

[Banging_limiter]

If I can get these springs to work I’ll have a sweet departure angle after bobbing the bed just like I wanted I seen a lot of samurai’s run the springs like this so i will see how they work before I cut the bed up.