the bodj's latest activity
-
Removal of fucked-out rear pivot tabs Time: 50 minutes Tools: Milwaukee Hackzall, Milwaukee 5” grinder with cutoff and flap discs... -
More updates. The front driveshaft from the rusty donor truck got replaced by a west coast unit with no rust from eBay. I threw in fresh...
-
I found it, current owner has gone through the truck and re-did the tube work and painted it. He is going to be racing it in June at...
-
That Budweiser paint job reminds me of when I was a kid so much. I had plastic models I built of both Mears Nissan and Ivan's Toyota. I...
-
Yup just no blinkers lol I gave up on that after the dash started smoking.
-
This was such a fucking fun trip! I had a great time! Awesome scenery, great trails, lots of 2WD rock crawling, crushing whoops, broken...
-
the bodj replied to the thread Chop Shop Builds.Progress is progress! Keep it up, bud! It's easy to get down on yourself, but bro, you didn't even know if you'd be able to walk again...
-
I'm an idiot. I didn't weld up the divits on the driver side frame rails, just the holes. Faaawwwkk. Its so much work for me to drag...
-
-
Just messaged E about doing some type of quick message board on here, almost like a big group chat. Not sure if that's even possible so...
-
Just need to quit ruining all the fancy metaluragistic magic by welding and install a bolt on snout. Impressive that the snout material...
-
the bodj replied to the thread Local Legend Project: Tur-BRO-yota.I approve of this. Throw on those bolt in snouts, run your OEM D44 hubs, and rock n roll the rest of the season until you build your new...
-
This is a lot of work just to cut it all off for the TTB swap….
-
Well I guess I’ll give my side of the story for the desert hot springs to big bear trip with tree trunk, Turboyota, bromainia, and...
-
Well that makes things significantly easier than! I’d go that route. I could be wrong but you should be able to run just about anyone’s...
