Klever's latest activity
-
Well I’m going to try swapping out my 600# lower rear spring to a 500# lower spring in the back see if that helps with the bucking. All... -
Klever reacted to Down For Mobbing's post in the thread Off-road Summer Social - July 19th San Diego with
Like.
We just put in our order for event shirt! Excited for these! Who wants one? -
Ok was double checking everything on the front end and I realized I had uca mounts welded onto the frame 3/8" too far back resulting in...
-
Klever reacted to Down For Mobbing's post in the thread Off-road Summer Social - July 19th San Diego with Like.
We're 8 days away and the vendor/display vehicle list is growing! This isn’t your typical off-road expo or parking lot meet packed...
-
Hey guys Weston over @GTS Customs here. Ive got some products released that i wanted to share on here! First up is Tube wiring hold...
-
OK.. @Raceranger97 here is the .026. Have to admit.. I cant see a ton of difference between last and this one. *note too. Last two...
-
We can deduce at least three things about the Nextdoor queer who went after you: 1. Virgin 2. Morbidly obese 3. Unemployed
-
I got kicked off of Nextdoor during COVID. I got kicked off Facebook. I've been kicked off of plenty of subreddits on Reddit. My email...
-
Guess they didn’t spend enough time to find your grindr profile….
-
I am bored and thought you guys might enjoy a dumb story. If you are not familiar with the website nextdoor... its basically a...
-
Also pick up new seats from PRP premier low backs with headrest. I have a 48" bench PRP bench for the kids in the back.
-
Update: I got the dash tube fitted in and all 4 tie ins from the existing engine cage to the dash tube. This ended up being a royal...
-
Klever reacted to Raceranger97's post in the thread Local Legend Project G4 AKA Quasi-Ghetto with Like.
Built one the other day using that exact gear set, different case and pinion support. But also using Strange components.
-
Klever reacted to Raceranger97's post in the thread Local Legend Project G4 AKA Quasi-Ghetto with Like.
Ya I’d keep going out. Attempt a .025.
-
Annnd..... @Raceranger97 here is a .021 shim which puts the pinion .003 further out than the original. Drive: (2 pictures) Coast
