Bpbuilt's latest activity
-
Front bumper wrapped up looking good, not pictured is the removable light rack for the three LP9s. Spare tire hold and jack hold downs... -
Trucks coming along slowly but surely, did some bed supports and dual shocks up front.I’m trying toKeep it as period correct as possible...
-
Got all the ifs junk cut off and the rear axle pulled all the dash and wiring ripped out going to mount the front and rear axles...
-
I know it’s a long shot, but anyone have a bumpside f100 5” Autofab kit before I buy new? If you have one on your truck sell it to me...
-
Bpbuilt replied to the thread Hydrolocked 1995 explorer.Got a few things done last night, camber was set and so was the toe should be in the ball park but will have to check when the weight is...
-
-
I have a first gen Tacoma with TC long travel, I added 4wd drive using parts from a 4Runner and Tundra. I did mine the most simple...
-
It’s a 32 gallon IRC that cost $530 but while I was looking an ad popped up that would sell it for $430 and then Walmart ad popped up...
-
2003 Chevy Silverado 1500HD with 197k miles on it. All suspension, both axles, and engine have less than 5k miles on them. I’ve lost...
-
Bpbuilt replied to the thread Hydrolocked 1995 explorer.Well everything is painted and starting to go together. Still a ways to go but happy with the progress so far!
-
-
Hahaha! The pre-runners can take one week to put together, but these silly race trucks need a lot more. I am running the stuck fuel...
-
Bumpity. last few months...
-
This is probably 2012ish Not a bad line, more of a result of poor planning and a lack of prep. The pivot bolt on the rear arm backed...
-
I stole Tyler’s Kuster’s
-
MCD is the Ed Hardy of off-road fabrication. prove me wrong.
-
That’s not bedside paneling… that’s heat shielding for re-entry. All it’s missing is a property of spaceX sticker…. Then she’ll be ready...
