THE NUCLEAR UNICORN

[Ajones880]

so clean!

Thanks, Dude!!

 

[Ajones880]

Update: Not too much going on, Built some -10 PushLock heater hoses!
I'm currently on the lookout for an NP241 32 spline driver drop transferase. If anyone has one, or know of a good place to grab one, please keep me posted. Thanks!

 

[Ajones880]

Weekend update: Built some dash access panels to make things a little easier to work on once its all back together. I'm in the process of building a panel for the center of the dash and the center console. I also got the Jamar Performance brake pedal assembly and Vintage air unit installed and mounted into their forever home. Ordered a transfer case too! I should be able to get the 4L80 in place anytime now!

 

[Austen2019]

A few more weekend updates.. Installed the new valve covers and added some flare to the center console panel. I'm going to start on the driver side panel this weekend.

Hey on the pic with your air filter what you going to do about the water going directly into the air filter. I only ask because I have the same set up and the 14s don’t fit but I did find this set up for under 100 bucks and the filter is off the shelf at autozone for 12$

 

[Ajones880]

Hey on the pic with your air filter what you going to do about the water going directly into the air filter. I only ask because I have the same set up and the 14s don’t fit but I did find this set up for under 100 bucks and the filter is off the shelf at autozone for 12$

There's a provision plate that covers said area to keep water diverted from the air filter. Chances of any water getting into the air filter without it are pretty slim, due to the valance air ducting holes being so small. A ton of water would have to flow through there in order to get into the filter.

 

[Austen2019]

There's a provision plate that covers said area to keep water diverted from the air filter. Chances of any water getting into the air filter without it are pretty slim, due to the valance air ducting holes being so small. A ton of water would have to flow through there in order to get into the filter.

Oh gotchya

 

[Ajones880]

Small Updates... Getting ready to get the Maximum transmission Reid super 80 and Transfer Case solutions NP241 into the Bronco. Currently waiting on the flexplate to arrive, should be here mid April. Built a rear removable storage shelf that will hold two Milwaukee storage packouts, one Milwaukee packout Cooler, a 12v Fridge, and some recovery gear under the jack skid. Moving like a slug...!

 

[Brett_408]

Hey nice rack

 

[Ajones880]

Hey nice rack