1985 4Runner

[SByota]

I have the same Sequoia axle in my 1st gen Tacoma. The width matches my long travel front end perfect. Brakes work good with the factory Tacoma master cylinder. The brakes are pretty big and may need 16+ wheels.

Have fun cutting off all 27 different brackets! I almost caught my whorl garage on fire with my plasma cutter when I did mine.

 

[Rooster.Fabrication]

I have the same Sequoia axle in my 1st gen Tacoma. The width matches my long travel front end perfect. Brakes work good with the factory Tacoma master cylinder. The brakes are pretty big and may need 16+ wheels.

Have fun cutting off all 27 different brackets! I almost caught my whorl garage on fire with my plasma cutter when I did mine.

View attachment 41626View attachment 41627View attachment 41628

Glad to hear you got the brakes to work, I have an FJ80 master so it should be good enough to stop them. I’m also on 17” wheels so shouldn’t be an issue there!

 

[Rooster.Fabrication]

Another successful trip in the books, this thing suprises me every time I take it out with how capable it is. Had a few moments at a good angle and we noticed my T-case output shaft was when we were heading back to the start. Just ordered a new seal and it should be ready to go again.

 

[Oh4Tahoe]

Have you seen the GFC camper for the 1st gen runners. Reowr!

 

[Rooster.Fabrication]

Have you seen the GFC camper for the 1st gen runners. Reowr!

They’re pretty slick! Too bad they cost more than I got this thing for