the_fablab_'s latest activity
-
THad some fun this weekend in the Rock Ranger with the fam. Found the limits of the rear driveline lol.
-
Tthe_fablab_ replied to the thread The Baja350 - a Dentside Story.with horsepowers and wheel travel I would shoot for 70-50 range IMO. Also where's your instance center with a lower link mounted that...
-
Tthe_fablab_ reacted to 84Prerunner's post in the thread Local Legend Don't Call It An S10 with
Like.
Only thing I can really add is having the one tie rod so much further forward than the other causes odd behavior when steering. Ackerman... -
Tthe_fablab_ replied to the thread Local Legend Don't Call It An S10.Look at your X axis you have on your drawing, see how the long beam tie rod end is short of the x and your short beam tie rod is dead on...
-
Tthe_fablab_ replied to the thread Local Legend Don't Call It An S10.I think you are still missing my first point which was your passenger tie rod/ driver side mounted swinger is in the wrong spot because...
-
Tthe_fablab_ replied to the thread Local Legend Don't Call It An S10.What you have drawn for the long beam should get you close enough you can start cutting stuff out to cycle, but I think you are...
-
Tthe_fablab_ replied to the thread Local Legend Don't Call It An S10.I am referring too the steering swinger that's mounted on the driver side frame rail. You know the one that steers the short beam that...
-
Tthe_fablab_ replied to the thread Local Legend Don't Call It An S10.Your driver side swinger is in a completely different area code from where it should be FYI, but I like that you can do 3D scans now...
-
TGears aren't currently installed but I have a new 9" 3rd and front diff parts ready to go. I went with 5:13 ratio
-
Tthe_fablab_ replied to the thread Hoopdee 94.0 Bronco.I would do supports to the bottom of the wheel openings. Other than that no additional supports are needed.
-
TImo an older pre def 8.3l Cummins diesel pusher is a solid “budget” choice. The 5.9 versions are solid but very slow towing
-
TTook it to KOH over the weekend and had a blast with it. Still for sale.
-
TI love the pizza cutter look Want to run 38x11.5’s on my power wagon
-
TRandom pics from Hammers.
-
Tthe_fablab_ replied to the thread The Baja350 - a Dentside Story.There is no way the truck will need a 400lb main rate, use the loaner springs to figure out your corner weights Mike, crank them down...
