smokeysevin's latest activity
-
smokeysevin replied to the thread 2003 Tundra Prerunner.Adding insult to injury there, the connector was mated but not latched so the other stuff was an intermittent fault. That one hurt... -
smokeysevin reacted to SaltyMethods's post in the thread T-Juan - `98 Toyota T100 4x4, 5-spd with
Like.
Did our supply run at Costco last night in prep for our yearly trip. $3,400 dollars later... -
smokeysevin reacted to desert_steve's post in the thread T-Juan - `98 Toyota T100 4x4, 5-spd with
Love.
The gussets alone will pull more ass than your T100 can legally haul. Looks good! -
smokeysevin replied to the thread 2003 Tundra Prerunner.If it makes you feel any better I had the same issue of no starter at all. I tore my whole dash, trans wiring, trans neutral switches...
-
So rad! If you don’t mind sharing, what’s the total length and length from pivot to the coilover and bypass of your mezi arms? I want to...
-
The majority of the insulation is 2” foam insulation board from Home Depot. By itself it works pretty good, I would like to cover the...
-
smokeysevin replied to the thread Tree trunks 87 FSB.What size AC do you have in your shop and how much insulation? Are you happy with that setup? I am planning my garage out now and...
-
So yah hey there people. Haha
-
Well back in all fours and drove around the block, time to get some miles on it! Next step is going to be the rear end which should be...
-
smokeysevin replied to the thread Casters for chassis dolly's.I can tell you the car dollies from harbor freight are a pain in the ass to move with a double jetski trailer on them so don't scab...
-
It’s been a hot minute since I’ve done any updates. My truck got a ton of maintenance and general work done earlier this year, between...
-
Ive seen A LOT of people looking for it (the steering) over the years, but have only heard of a couple people finding it. Maybe you...
-
I’m thinking like u joint from big rig driveline. I would build it myself, my plan was to get a big rig driveshaft and use it to make...
-
I think many over complicate it and the ball works fine in most cases if set up correct/level to start. I don't know if the fancy...
-
smokeysevin replied to the thread Overland trailer.I have always wondered if you could use a bigass spherical bearing as a hitch rather than a pintle style to keep it from slamming...