SEf150's latest activity
-
SThanks its been a lot of fun over the years. Yota axles. rock assault front ifs width rear 4:88s arbs og longfields
-
SHey what's up fourm. Introducing myself and my beater. Central Washington is home. My rig is a 89 trooper RS. 1uz swap toyota axles...
-
SThe Mouse in 3 mins.
-
SHorns tacked on and main tube bent and tacked in place. Need to trim/cap the ends and add more tubes. Tucked as tight as I could...
-
SSome more small details/learning opportunities I’ve encountered throughout my time with the Bronco. Mounted the winch solenoid behind...
-
SSome snow wheeling action from this weekend.
-
SThanks Geoff! It’s been a fun truck so far, I’ve put a ton of Nevada dirt miles on it as well as a trip to Baja in 2023. Loaded down...
-
STime to start a build thread for my Bronco I guess. I found this thing on Facebook marketplace in Oregon for like $2000 bucks or...
-
SRATR 2024 was one for the books. We started day one in the first row spot 3. I personally like to start mid pack and was a little...
-
SSEf150 reacted to sand_in_my_mouth's post in the thread OBS F150 2wd to 4wd conversion: Any transmission/t-case advice? with
Like.
@SEf150 that's badass! Pretty much exactly what we're going for: bed rack/tent, 35s and lowish center of gravity. -
SSEf150 replied to the thread OBS F150 2wd to 4wd conversion: Any transmission/t-case advice?.Mine was originally a 4.9/m5od truck, I found a guy parting a 91 f150 and bought the front end, trans/tcase and x member. Everything...
-
-
SSEf150 replied to the thread OBS F150 2wd to 4wd conversion: Any transmission/t-case advice?.I'm in Lucedale, on the MS/AL line. I like MS, much better than south Alabama.
-
SSEf150 replied to the thread OBS F150 2wd to 4wd conversion: Any transmission/t-case advice?.So, I recently did a scsb 2wd to 4wd, and have a m50d, as best as I could find no one makes a factory replacement driveshaft. I ended...
-
SWell might as well post a little project I picked up 1976 Yamaha DT125 hasn’t ran in a few decades but stored inside paid $400 and...
