Kellyex1450's latest activity
-
Kellyex1450 reacted to 85Yota's post in the thread Rear End Full Floater Hubs? Options and Opinions with
Like.
No pics but grind bevel on tubes did 3 passes and then slid in axles, measured gap between axle and hub and cut end of axle the length... -
Kellyex1450 reacted to 85Yota's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
I've also done it on a GM 14 bolt, but I got another set of axle tubes with spindles off Ebay. Then I cut the tubes and welded them...
-
I don’t understand fireworks in general. Why does every desert trip have to have fireworks all night long? I feel like since Covid it’s...
-
Kellyex1450 replied to the thread KOH Fireworks issue / discussion.The only “illegal” fireworks I respect are the ones with a fuse so short it feels like you’re diffusing a bomb in an action movie. If...
-
Kellyex1450 reacted to 85Yota's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
Get a duly rear axle to start with.So you can cut it whatever width you want.When welding on the trail gear unit, bearing cups
-
GORMAN THROTTLE & FREEDOM MARCH 20–22nd Friday–Sunday For 4x4, All-Terrain Vehicles, Dune Buggies, Dirt Bikes, Side-By-Sides OFF-ROAD...
-
Kellyex1450 reacted to 85Yota's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
https://www.polyperformance.com/solid-axle-industries-d60-forged-wheel-hubs I'm checking stock on these from Solid axle now
-
Kellyex1450 reacted to Brett_408's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
The Branik 5x5.5 unit bearing looks like its standard with 1/2 studs I'd be curious to know if 5/8" is possible looks like it probably...
-
Kellyex1450 reacted to Brett_408's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
One other issue I found out with the Solid D60 spindles is the OD is like 2.92" on the part the slides into the axle housing tube. This...
-
Kellyex1450 replied to the thread Rear End Full Floater Hubs? Options and Opinions.I spoke with a guy at Solid Axle today — he seemed to really know his stuff. He said the 14-bolt hub can work on Dodge/GM Dana 60s, but...
-
Hello from Draper I'm Grady, sold my track car project corvette and my Miata to go back to playing in the dirt where i belong instead of...
-
Kellyex1450 replied to the thread Grumman LLV Mail Truck.this things going to look AI generated when its done! keep up the progress and good work!
-
Kellyex1450 replied to the thread Local Legend Don't Call It An S10.No asking needed, just act like your going to throw a beer and everyone will film you!
-
Kellyex1450 replied to the thread Rear End Full Floater Hubs? Options and Opinions.Man, I keep coming back to this thread—so much good info. Should be a sticky. Just picked up a Dana 60 and want 5 on 5.5 while keeping...
-
Kellyex1450 reacted to triple_fcked's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
I have been guilty of using a cutoff wheel to pie cut the tubes on an axle housing and welding them shut to make it easier to...