Yes, another Bronco (1995 Eddie Bauer)
- Thread starter sixdee9er
- Start date
sixdee9er
Well-known member
We are live!!
sixdee9er
Well-known member
sixdee9er
Well-known member
sixdee9er
Well-known member
Been slowly dialing this thing in at the same time i have been doing slave hours at work. Haven't touched the dirt yet.
This thing was running decent but had about 15 codes with a check engine light. Found out the timing had been advanced at some point by a previous owner due to the incorrect ICM being installed. Not sure exactly how that works, but the previous owner was trying to trick the ICM into working correctly on the incorrect vehicle.
I would have made the same mistake because I could have sworn this truck is a 1994, but turns out its a 1995. I had been looking at the wrong date on the door panel and never took my time to make sure i was looking at the MFG date not the Model Year.
Made some toe adjustments as well because this thing was a HANDFULL on the highway. If I almost cleaned you out on the i10 between yucaipa/redlands, my bad, i was doing my best. Much better now.
Parker in two weeks will be the first dirt shakedown for this hotrod. Looking forward to getting it further dialed in.
This thing was running decent but had about 15 codes with a check engine light. Found out the timing had been advanced at some point by a previous owner due to the incorrect ICM being installed. Not sure exactly how that works, but the previous owner was trying to trick the ICM into working correctly on the incorrect vehicle.
I would have made the same mistake because I could have sworn this truck is a 1994, but turns out its a 1995. I had been looking at the wrong date on the door panel and never took my time to make sure i was looking at the MFG date not the Model Year.
Made some toe adjustments as well because this thing was a HANDFULL on the highway. If I almost cleaned you out on the i10 between yucaipa/redlands, my bad, i was doing my best. Much better now.
Parker in two weeks will be the first dirt shakedown for this hotrod. Looking forward to getting it further dialed in.
Tree trunk
Well-known member
Turns out I had a full inch toe out 
I just thought it was my steering was too quick lol
What did you end up with on your toe in/out set up.
Also, how’s your exhaust sistuation? When it was drivable… did you ever rip around with the back window down without getting gassed out?
I just thought it was my steering was too quick lol What did you end up with on your toe in/out set up.
Also, how’s your exhaust sistuation? When it was drivable… did you ever rip around with the back window down without getting gassed out?
sixdee9er
Well-known member
Truck trip this weekend.
sixdee9er
Well-known member
sixdee9er
Well-known member
300 dirt miles this last weekend. Blythe to amboy, then amboy to needles. and needles to amboy on dirt again. Not to mention drove the highway to /from as well. Didn't turn a wrench on this thing all weekend.
Super pleased, this is essentially what i built the thing for and it was 100% up to the task.
A couple small things to address, but she is a runner.
Missed this one..
Exhaust is out just before the passenger rear tire. I have quite the weather stripping setup on the back window, as of now seems to be almost 100% sealed. No exhaust fumes at all.
Super pleased, this is essentially what i built the thing for and it was 100% up to the task.
A couple small things to address, but she is a runner.
Turns out I had a full inch toe out
What did you end up with on your toe in/out set up.
Also, how’s your exhaust sistuation? When it was drivable… did you ever rip around with the back window down without getting gassed out?
Missed this one..
Exhaust is out just before the passenger rear tire. I have quite the weather stripping setup on the back window, as of now seems to be almost 100% sealed. No exhaust fumes at all.
sixdee9er
Well-known member
All the way up by the dump/motocross track. Went through midland and palen pass
