Flat strap bender

D

Doubleggregg

Active member
Joined
Jul 27, 2023
Messages
108
Location
Winchester, Ca
Anyone have a recommendation for a flat strap bender sorta like the TMR machete thing? I saw a DIY bender made from angle iron but cant find it again to duplicate. I need to bend some 2" x .080" aluminum 90 degrees with a 1" radius at the corner. Trying to build a coolant surge tank with a one piece outer piece instead of welding it all together.

Gregg
 
Tack weld a piece of 2" tube vertically to your welding table (2" OD = 1" bend radius), tack weld a vertical piece of round stock to act as a stop for the stationary side of the strap. Use your hand to bend it around the tube since it's thin material. EZ Peasy
 
You must log in or register to reply here.
Back
Top