RMC's latest activity
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.Yes called the d609 by many. Solid cheap alternative -
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.I do remember they were out of stock on bearings and yes rear snouts fit rear hubs once we located correct bearings from third party...
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.Great question for solid axle industry. I just finished assembling a set into a 9” recently but we had to get bearings elsewhere as they...
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.You can install the snouts on any weldable rear end. I wouldn’t advise 8.8 as plug welds on cast housings break free and it a waste of...
-
Thank for the addition. Here's a pic of my off road toy
-
Springs: 22”x400lb 8”x350lb
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.Here’s some pics to explain the contrast I described above in last comment. First is front hubs used as rear, with drive pucks and is...
-
-
RMC replied to the thread Thoughts on Jamar hubs?.For those who don’t know this dude( Philo ) is smart as a whip with ecm shit and configs, wiring and mechanical. Very solid rep.
-
RMC replied to the thread Thoughts on Jamar hubs?.Chris Philo!! Been a while glad to see you are here. 👏🏻
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.You want the cheap route or the expensive route. I can advise both. Cheap route solid axle industries 5 on 5.5 rear hubs, snouts and...
-
RMC replied to the thread Leadfoot Grey 95 Bronco.Heads I’d suggest I.G. Diego in riverside, good prices for from what I’ve been told, good prices for engine work and cylinder work. If...
-
I have one from the time I swapped gears into the current housing but that was very minimal work compared to the whole swapping gears...
-
RMC replied to the thread Anybody have tips for regearing?.You’ll need a mag base a plunge indicator to check backlash. You can get a cheap one on Amazon it should due. I advise .0005 accuracy...
-
-
Work station for the rear not ideal or organized but gotta make it work using whatever the bronco has for tools to do the change
