Klever's latest activity
-
That truck should have 7/8" kingpins, which are totally fine — even for hard prerunning. The weak point isn’t the kingpins themselves... -
This thing is supposed to be a cheap beater 🤣 trying to avoid going tons to be honest. With my new prerunner build in the works I don’t...
-
The front on Jet Blue was a Robby hood and the rear were custom from Mike McQueen https://mcqueenfiberglass.com/ I spent many years...
-
I appreciate the reply and this aligns with my though process. I was explaining all these points to my son last night on our drive to...
-
You got you a smart kid! The secret to beams is mostly in the steering same as arms One important point on beam geometry is the radius...
-
In regards to center mount radius arms, i personally dont see much of a benefit as Marcel said. Additionally you have to disassemble...
-
Headers, cats deleted, and a magnaflow round stainless muffler got some bark for the old girl. Hoops and crossover is ready to weld...
-
Got the A-arms and clevis installed tonight just gotta throw the spindles and tie rods and shocks on the lower arms to see where I need...
-
Well we kept the front glass and fixed it because i ran out of truck funds. She also got 4 new doors and a new roof 2 days before the...
-
Some pictures form prep/ junk yard fun. Doner truck lived a good life. Ps u can fit most of a f150 in the bed of a short bed f250.
-
Well 1-10-26 we got the truck over to my dads power washed everything and then it decided to start snowing. Last night 1-13-26 it was...
-
Hello, my fellow beamers! My son has a 69 f100 that we will be starting a build on pretty soon. I would like to get some options on...
-
Just went through my total build receipts when I started this I wanted to spend $15,000 that was my goal. All said and done I’m...
-
New never used , 1” bore 250 for the pair , will ship on your dime Basically buy one get one free
-
Couple hours each night after the kids go down chipping away at it. Got the old mid travel kit taken off and the old shock towers cut...
