Klever's latest activity
-
What up! Here’s some pictures of my recently finished 6100 truck. Built this H&M designed chassis and front suspension after hours at... -
Hi. I'm still here and the truck is home. Maybe I should update this today...
-
2001 Chevy Silverado Brand new build. Less than 1000 miles. Motor/trans- 330” moruzzi special Speed engineering 1 7/8” long tube...
-
Finally got almost everything bolted up to the front. Needed to order some high lift jackstands to relocate the current 6 tons ones so...
-
Currently just have a set of reclining buckets and there's just enough room to strap a small car seat against the back wall between the...
-
Klever replied to the thread Mechanic liability / customer recourse.Well then sounds like the CP3 is shitting the bed then..maybe. Damn!
-
Epic day doing some crawling I was unsure if the LSD worked or not after I rebuilt it… found out today it works awesome. Climbed some...
-
Fun weekend in expo Chiva falls run with the family saturday morning. Got a good monsoon tuesday night so we were hoping there was...
-
Mine sits so much higher than that. I’m at 9” I think. Keep in mind these are 35s too!
-
Klever reacted to exp24's post in the thread Installing the 74 Weld Swaybar on Our 1993 Ford Ranger Prerunner with part numbers and cost with
Like.
Nice write up! We run the same setup on our ranger, super happy with it. Just had to replace the arms after 10 years of use. We used... -
I'm a 4th generation fence contractor. My family and I run Frontier Fence in North San Diego County. We have been here since 1955.
-
Thanks Bodj! Got the ididit shortly column in. keyed, tilt unit. pretty sweet so far - but wish it had a little more room for mounting...
-
Klever replied to the thread Mechanic liability / customer recourse.Gregg, put a new rail pressure sensor in (GM one). Then a lift pump might be what you need. Right now your CP3 (high pressure fuel pump)...
-
you look like a homeless tweaker.
-
Klever reacted to Down For Mobbing's post in the thread Installing the 74 Weld Swaybar on Our 1993 Ford Ranger Prerunner with part numbers and cost with Like.
Right! I have race hubs for front and rear but that will snowball into $12,000 ish to get the front and rear set to accept them. Till...
