Hansoloo's latest activity
-
You have a ride height of 19", lowers are at 21" and uppers 27.35". Your u joint CL at the trans needs to be lower in the chassis to... -
2.6" of plunge is too much, 1" or less is a number to shoot for. 34-36" of travel is not gonna happen without bad side effects, 30-33"...
-
First parts have landed! well, parts of parts? DIY offroad beam kit.
-
Steady progress on the truck, landing more tubes for the engine cage
-
-
Did some light trimming to the firewall to clear tires
-
All the up travel
-
Hansoloo replied to the thread 78 K10 with a 6.0L twist.Yeah I’m thinking I’ll try and see how long the d44 can stay alive. If I link the truck further on down the line I’ll go to a bigger...
-
Hansoloo reacted to RMC's post in the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first… with
Like.
Pitman arm stuff to make your own length arm using factory forged parts modified. Crossed drill, plug weld and weld top and bottom... -
Had an epic weekend in glamis. There were so many people out there I couldn’t believe it. Camped on gecko and kept it mellow all weekend...
-
Figured this thread needed some action shots.
-
Hansoloo replied to the thread 1992 ford explorer.Not sure about threat motorsports but majority of Companies out there with beam kits like that for 2wd will still use a 4x4 d44 knuckle...
-
Trucks coming along slowly but surely, did some bed supports and dual shocks up front.
-
Everyone thinks leaving the hardware loose is the way to go about it, but you could oval the holes of your brackets. The two big...
-
Hahaha! The pre-runners can take one week to put together, but these silly race trucks need a lot more. I am running the stuck fuel...