bullnerd's latest activity
-
BMarketplace has been kinda poppin lately. I picked up some beards that happen to match the interior really well. They almost look...
-
BMost Exellent! I’ll have to show this to my wife and explain this is how a new project truck should be received 👌
-
BCranking out more design work, everything is 3/16 and 1/4in steel. Already have some prototype parts cut, just trying to get some...
-
BBronco got put on pause for a few months. Got the rear axle leak fixed, turns out I tore the innerseal when installing the axle shafts...
-
BWe made it to the dirt boys! Minor issues like leaks and Amazon switch panel not working. The stock shifter set up is pretty ass so I’ll...
-
BGot the parts put on last night and tested them out today. What a difference! Bars came up a bit and it made a huge improvement in terms...
-
BTrip number one of the season in the books. Nothing special, just jammed up to Williams Az to blast some guns, and get outta city for 2...
-
BNo LS swap this time! 🏳️🌈 Gave the ol 5.0 the ATF engine flush treatment, and she settled right on down 🤘🏻 Drained approx 2 quarts of...
-
Bbullnerd reacted to Turboyota's post in the thread Project 4Skinner: Unclean, uncut, unkosher and unashamed with
Like.
@FatJeff scored a fucking OG Doug Thorley Tri-Y header! With this newfound power, FatJeff beat a Kia Soul in a drag race. What a... -
BThe base valving is decently close for a spring over set up as long as it’s cycled clean all I did was add a small amount of rebound I...
-
Bbullnerd replied to the thread RSS Shop Bronco.If you're ever in the mood to post how you set them up I wouldn't mind. I'm going to use them on mine also. Someday.
-
BThey work pretty good I revalved them once and then never did anything else to them for like 4 years, I’m going to need to Revalve them...
-
Bbullnerd replied to the thread RSS Shop Bronco.How do the raptor shocks do in the rear? Did you re-valve or just run it?
-
BStill need to cycle and figure out pinion angle as well. Also going to be using a gen 2 raptor IBP unless I can find a 3.0x16 somewhere