2012SVTSC's latest activity
-
f -
2012SVTSC replied to the thread 1973 F250 Prerunner Project.Here is a bit more progress, mostly the beams getting closer to being done and starting to fit a truss on the old d60.
-
-
Figured I throw in a picture of the shop I work in, been here for 13 years doing sheet metal fabrication for a hvac company. Me and my...
-
Sunday Funday mountain rip Dirt miles: 25~ish Near Beers: 1 Children: 5 Snacks: Snickers ice cream bars & skittles gummies Vehicles...
-
Had a local homie weld up the Taco Bell Tommy Trailing arms for me to help parallel path some progress while I was starting a new job &...
-
Thought it would be cool if we had a thread for garage tours, show what you work out of and some of the tools you can’t live without. I...
-
I like having less pre-load and a stiffer spring for sending it.
-
So it begins…. Tubing picked up and ranger shell getting prepped. Last pickup of sheet metal parts by next week and dropping off at...
-
Front valence mounted… Now to slap the front together for the second to last time so it will be a roller . Going to Line - X this...
-
2012SVTSC reacted to Thomas Built Motorsports's post in the thread Thomas built motorsports 07 Ranger with
Like.
-
Got the motor mostly together. Got the trans coolers tacked in and line placement going
-
Update on the truck from Daniel killing it on the truck. Had to ditch the brake booster and going to a full manual set up, Daniel is...
-
Little by little but the details matter and I keep telling myself that’s all that counts.
-
2012SVTSC reacted to turbomonty's post in the thread The Turbo Glue Factory: Boosted Colt Build with Like.
Time to fight the final boss in fabrication Main center link and then baby tie rods to the knuckles
-
2012SVTSC replied to the thread FOA shock pre-use tune up..I do still run the FOAs on the rear of my raptor. At this point they work good. I rebuild them build every season, but they do not...
-
