Yes, another Bronco (1994 Eddie Bauer)

[Austen2019]

I can’t find swp where is that steering kit ?

 

[95_Bluwhale]

I can’t find swp where is that steering kit ?

Southwest performance out of Ramona, ca

 

[sixdee9er]

Headers, cats deleted, and a magnaflow round stainless muffler got some bark for the old girl.



Hoops and crossover is ready to weld.





Trying to match the bumper to the accent stripe.

 

[sixdee9er]

Happy MLK day

 

[sixdee9er]

Anyone know of offset weld on disc conversion brackets for a ford 9”? Ruff stuff is on back order and I can’t find others:
https://www.ruffstuffspecialties.com/collections/brake-products/products/r1261

Moving right along on getting the rear end done, those brackets may be what hold us up if there’s no alternatives.

 

[sixdee9er]

Also need to figure out an Air Intake Tube and Filter for this hog.

Any suggestions are welcome!

 

[Turboyota]

Also need to figure out an Air Intake Tube and Filter for this hog.

Any suggestions are welcome!

Spectre from VatoZone

 

[Tree trunk]

You had mentioned wanting to do a Donaldson filter in previous post.
This is how I did mine,
Though my intake tube is kind of shitty, it’ll get a redo some day

 

[Brett_408]

Tree Trucks Donaldson is definitely the route to go. Heres my "temp/permanent" intake with a simple K&N filter. Works fine.

 

[bullnerd]

look for the Camburg kid that posts his bronco everywhere.

I think they squeezed the Donaldson between the plenum and master.

It looked pretty good.

 

[Brett_408]

@Tree trunk what air filter housing is that? Looks like a composite UMP?

 

[Tree trunk]

Donaldson B080080 - Cycloflow‚Ѣ... https://www.amazon.com/dp/B015YRLTPI?ref=ppx_pop_mob_ap_share

Yup, Pretty much the same deal as the UMP filters with a composite housing
-it actually has the same filter elements

 

[sixdee9er]

Getting close with everything I have so far. Need to pick up the third members tomorrow. Rear brake kit was delivered today. Then a few loose ends like exhaust, air filter, and rear bumper. Ended up finding a k&n intake tube for a good price locally. Probably just put the k&n filter on for a few weeks until I figure out a paper element that will fit.