UR_Mawm69's latest activity
-
After a successful desert season, outside of eating 4 or 5 8.8 ring and pinions and a few trips to Mexico we planned to dive into a roll... -
I am determined to keep this 2” drop bracket kit alive hahah. These are essentially a replica of the factory ford stx brackets and...
-
UR_Mawm69 replied to the thread BAD LINES GOOD TIMES PODCAST.I'll watch/listen 2morrow 4 sureeeeeeeeeeeeeeeeeeeeee yo
-
Live at 2PM or when it finishes uploading. 🤡
-
UR_Mawm69 reacted to Mullen's post in the thread smog exemptions moving from 1974 to 1990 and more.... with
Haha.
You misspelled Epstein… -
UR_Mawm69 replied to the thread Bachelor trip on the Mojave.MOOOOOOOOOOOOAAAAAAAAAAAARRRRRRRRRRRR PICS!!!!!!!!!!!
-
Some more photos from day 1
-
UR_Mawm69 reacted to Bruce_is_boring's post in the thread Single Cab Short Bed F250 build with
Angry.
Did the tism wake up on the wrong side of the bed bud ? -
UR_Mawm69 replied to the thread 2025 OFFROAD EXPO OCT 4-5, OC FAIR GROUNDS...i wont be there any day. so fuck you. life could always be worse. shut your old mouth.
-
UR_Mawm69 replied to the thread Single Cab Short Bed F250 build.pointless to build a fullsize single cab truck that only weighs 69 lbs pointless to shorten the bed because now you will HAVE TO hookup...
-
UR_Mawm69 reacted to Bruce_is_boring's post in the thread Single Cab Short Bed F250 build with
Like.
Alright , this post is long overdue , and with enough flack from Elliot im finally here to give a write up about my 2011 Single Cab... -
UR_Mawm69 replied to the thread Chop Shop Builds.i have no pics as i wasn't here when he was working on shit, and its all put away and covered up now, but this comment by the Almighty...
-
UR_Mawm69 replied to the thread 2013 Escalade ESV mid-travel abomination.i would jizz myself if this thing had 37s on it. hhaha but i know thats not realistic. haha
-
UR_Mawm69 replied to the thread smog exemptions moving from 1974 to 1990 and more.....some fucking George Flloyd shit..........................
-
And then finally got around to cutting holes and slanging tube's yesterday and got the mains bent up for the engine cage and the pass...