Turboyota's latest activity
-
That truck should have 7/8" kingpins, which are totally fine — even for hard prerunning. The weak point isn’t the kingpins themselves... -
With the Sequoia running and successfully completing an offroad trip with the family my mind is starting to wander back to this and...
-
Turboyota reacted to Giant Geoff's post in the thread 2wd f250/f350 suspension; what’s out there? with
Like.
I got more done. The front is getting 18" of travel out of the stock beams and starting on the rear. -
Made a fun discovery while tearing down for putting in the new wiring harness
-
Spare drive shaft will live here on top. Hopefully it’s not needed but it will be accessible. Also if any one is in need of a ridgid led...
-
Not sure if this counts, but the owner of my old ranger sent me a pic of “Scarlet” tucked away in his garage in Prescott AZ. I’m...
-
This identifies as a truck too, as far as I can tell
-
Well if you follow my page or instagram svtgiles you already seen the pictures and videos but decided since it hasn’t been started since...
-
Center mount radius armis for chasing the best geometry out of beams, lots of race trucks do it for this reason, it helps the chassis...
-
Turboyota reacted to 84Prerunner's post in the thread Drilling out steel wheels for 5/8 studs with Like.
I did an old spare I had with a drill bit and counter sink. No issue in the few times I ran it
-
It's less than 1% difference between the two. The slip in the dirt more than allows for that difference.
-
Just went through my total build receipts when I started this I wanted to spend $15,000 that was my goal. All said and done I’m...
-
I have the same Yoko's you just put on got them new about a year and a half ago. Love them they run smooth on pavement and work well...
-
I had chat GBT spray paint my fenders and hood black, I haven’t done it yet, but I kinda want too 😳 I also don’t want to get...
-
You got you a smart kid! The secret to beams is mostly in the steering same as arms One important point on beam geometry is the radius...
