turbomonty's latest activity
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.Liter of water cradle Switch guard rail -
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.My little toaster oven is coming along
-
-
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.Passenger side main header done
-
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.When I swapped oil pans a while back these bits where in the bottom of the couriers old motor. Might need new belt tensioners
-
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.soon my new shifter will be here
-
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.Anyone ever attach your steering shaft support to the A pillar? the idea came to me from these helmets....
-
-
turbomonty replied to the thread The Turbo Glue Factory: Boosted Colt Build.Bent up the last piece of sheet wraps tight on the drive shaft loop on the rear a couple 1/4" screws hold the bottom of both sides down...
-
-
I have a unique garage/shop setup especially for a house in the Bay Area. It's always been difficult to explain, I've always said that...
-
Pipe stands for the win. You can level the vehicle easily& have more space to move shit around under the truck. Acme screw makes...
-
30 minutes with my hands, wheelchair, and a blower...... all clean again and ready to start working on shit...
-
turbomonty replied to the thread Garage or shop tours.work bench of pleasure cnc lathe back from the dead cutest horizontal mill everyone should have. this was 650 shipped from ohio! parts...
-
-
turbomonty replied to the thread Garage or shop tours.bread and butter cnc mill from Taiwan. god bless them! 3 phase of fire up on the wall working great hi/low speed drill press area
-
-
turbomonty replied to the thread Garage or shop tours.9000# japan cnc that needs cash for electronics mechanical press brake of doom. 6 feet wide or 5 foot throat home built press frame
-
-
Figured I throw in a picture of the shop I work in, been here for 13 years doing sheet metal fabrication for a hvac company. Me and my...
