troysladeck's latest activity
-
troysladeck replied to the thread RHDTTBXJ.Need help with springs. 2.5 x 12” coilover and 2.0 2” bump stop. I don’t really have an easy way of weighing the truck as it sits but it... -
troysladeck replied to the thread Tie rod end flip for ttb? Any issues?.Bump. Did you ever flip them?
-
I’ve done it on my I beamed ranger, I would assume it’s the same, I did do a half ass one on the expo before the dez probably needs re done
-
troysladeck replied to the thread Pearl, the 93' Explorer.Could be your alignment, too. Do you know how to do a proper TTB alignment?
-
-
It will also pull the wheel back slightly, unless you have the room in the threads to compensate. But yes, 2"x.250 can be bent with...
-
troysladeck replied to the thread RHDTTBXJ.Anybody know if its possible to bend 2” .250 wall tube? The radius arm hits the unibody before full bump. Putting a slight bend in it...
-
-
troysladeck replied to the thread RHDTTBXJ.These look great. I like how you did the flat front plate on the driver beam instead of the kit
-
The DIY dana 44 plates fit up good. I cut a set out and used about 3/4 of the plates in the kit. I did 2" wider beams so I modified the...
-
I think you win for most things packaged on a toyota pick up. The ingenuity is awesome on this truck.
-
-
troysladeck replied to the thread RHDTTBXJ.Making progress!! Crossmember pre painted for black alloy armor. Will get final layer once installed and welded Frame stiffeners and...
-
-
Structurally, I love this X behind the cab. It’s 1.5x0.058wall 4130, has Bitchin formed saddle gussets, and looks great. From a storage...
-
Recent updates that I haven’t posted about yet. Decided I needed to add a structural tube in the orange tape location Materials...
-
troysladeck replied to the thread RHDTTBXJ.Its going to be tricky, the steering gear is almost directly in line with the driver side pivot and theres only an inch or two of...
