RMC's latest activity
-
RMC replied to the thread Anybody have tips for regearing?.Either type will remove the race side from the housing tip wise. Hand me your pinion and new bearing I can remove and install... -
-
RMC replied to the thread Anybody have tips for regearing?.
-
-
RMC replied to the thread Anybody have tips for regearing?.Im only line an hour away, when you way pinion bearing do you mean the half on the pinion shaft or the half on the housing? Slide hammer...
-
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.Gotta make sure that bitch is bent straight after trussing. One thing the old school guys did to straighten was heat with rosebud and...
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.Pucks pucks. Typos: 35 spline pucks installed for ground bar
-
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.If you have the ability to machine e bearing housing pucks and third member picked and get a ground bar tkk on pads through you know she...
-
RMC replied to the thread Anybody have tips for regearing?.What’s the hang up? What city are you located in? You could be 1k mikes away.
-
Thats a Crest depiction of an eagle. you should look into what the different animals and symbols on crests mean and why they were used...
-
RMC replied to the thread Bumper light bar.Sold 8 with the bar. None remaining.
-
RMC replied to the thread Whats an ancient specialized P2 worth?.Mine might be p1 I can’t remember
-
RMC replied to the thread Whats an ancient specialized P2 worth?.🤣 Pogs. I have that same bike, mine is converted into adult sized BMX dirt jumper. I still love that frame.
-
-
MAAAAANNNNNNN I've wanted one of these for decades! That thing is slick!
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.It’s all good info to know before anyone goes this route.
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.The one downside of attempting to use 14 bolt rear hubs as rears is using 5/8 or larger studs. Studs are pretty tight to the hub at 5 on...
-
RMC replied to the thread Rear End Full Floater Hubs? Options and Opinions.No it can’t. Axle is bolted to hub via the small bolt circle on the flange. The hub is secured to the snout via dual locking spanner...
-
