RMC's latest activity
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….I got some Jeep Cherokee pics coming. Long arm diy stuff ect. As well. Just throwing shit out there to keep you guys motivated. If my... -
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….I got some core support pics and fender stabilizers for broncos and f150’s up next if I can find them in my library tomorrow. Also for...
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Made it roll to get it gone when dude was broke. Never got to finish what I started.
-
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Some shitty welds because I was half faded and motivated but the take away is maintenance. 4 quick couplings core support is removed, 2...
-
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Random bronco stretch pic I did a few years back that dude was supposed to get shell modified at Mcniel even though I got him a race...
-
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Press in d44 back side snout plugs to run d44 hubs 2wd. I can’t remember if these were for d44 or desert specialties snouts but someone...
-
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Forged arm not cast required for this ghetto fabulous action.
-
RMC replied to the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first….Not the strongest way to get the job done but it lets you make a pitman arm in length and offset of your choice.
-
RMC posted the thread Random fabrication thread to give people ideas on builds. Core supports, fender mounts, general jackassery. A good luck thread I’ll go first… in Fabrication Tech.Pitman arm stuff to make your own length arm using factory forged parts modified. Crossed drill, plug weld and weld top and bottom...
-
-
I saw these in person. A work of art. I hope to see what this ever went / going on. First time I've seen a uniball for a knuckle...
-
Another glamor shot, because why not
-
Mid-travel time, desolate setup, 18 hours (i think) of wrenching but the results were worth it.
-
Yea, those look like the right parts for D44 6 bolt. Blue boot BJ's from Napa... stock D44 knuckles/snouts/brakes and drill out the...
-
RMC replied to the thread Flight industries knuckles.Andy is one of my produce sets of the 5 stud but I inverted them to 5 bolt to beef up the bolt size vs stud size. Andy has been beating...
