RMC's latest activity
-
Yea, those look like the right parts for D44 6 bolt. Blue boot BJ's from Napa... stock D44 knuckles/snouts/brakes and drill out the... -
RMC replied to the thread Flight industries knuckles.Andy is one of my produce sets of the 5 stud but I inverted them to 5 bolt to beef up the bolt size vs stud size. Andy has been beating...
-
RMC replied to the thread Carly's 96.I also wanted to say few dudes have the patience to make everything by hand 100% bolt on. You and I spoke on this more that once but I’m...
-
RMC replied to the thread Carly's 96.
-
RMC replied to the thread Carly's 96.I remember the day you hauled it home you were telling me how clean it was and you diddnt want glass because the body was perfect. I...
-
RMC replied to the thread 1992 ford explorer.D44 ball joints are pretty hard to kill. I’ve ran them with 33,37,and 39” tires they can change with a lot just make sure you get...
-
RMC replied to the thread 1992 ford explorer.D44.
-
RMC replied to the thread 1994 Desert Copper Bronco.Why have you not added swing set steering? Just curious. None of that will get bent in the future so long as tie rods are same length as...
-
I wish I had a cunt hair of your attention to detail or patience. Nice work
-
RMC replied to the thread 1992 ford explorer.I got stuck with a guy once hard pressed to keep his d35 beams so I made him a set of uniball camber adjustable knuckles. I Dont think...
-
-
Got all the ifs junk cut off and the rear axle pulled all the dash and wiring ripped out going to mount the front and rear axles...
