Klever's latest activity
-
Guess I’ll finally make a post. New to this forum, but was on Dezertrangers and TTORA back in the day. Out in AZ. Some might remember... -
Not sure if this counts, but the owner of my old ranger sent me a pic of “Scarlet” tucked away in his garage in Prescott AZ. I’m...
-
Klever replied to the thread For Sale 97 f250 CCSB LS swapped.Rad truck!
-
2wd. Was a diesel so smog exempt in California. Has 6 liter LQ4 rebuilt by L & R engines in Santa fe springs. 4l80e from Roy's...
-
Got two more tubes to do on the engine cage and this is done! These two tubes specifically I have been dreading cause they are both...
-
Oh boy! Can of worms officially opened.
-
That truck should have 7/8" kingpins, which are totally fine — even for hard prerunning. The weak point isn’t the kingpins themselves...
-
This thing is supposed to be a cheap beater 🤣 trying to avoid going tons to be honest. With my new prerunner build in the works I don’t...
-
The front on Jet Blue was a Robby hood and the rear were custom from Mike McQueen https://mcqueenfiberglass.com/ I spent many years...
-
I appreciate the reply and this aligns with my though process. I was explaining all these points to my son last night on our drive to...
-
You got you a smart kid! The secret to beams is mostly in the steering same as arms One important point on beam geometry is the radius...
-
In regards to center mount radius arms, i personally dont see much of a benefit as Marcel said. Additionally you have to disassemble...
-
Headers, cats deleted, and a magnaflow round stainless muffler got some bark for the old girl. Hoops and crossover is ready to weld...
-
Got the A-arms and clevis installed tonight just gotta throw the spindles and tie rods and shocks on the lower arms to see where I need...
-
Well we kept the front glass and fixed it because i ran out of truck funds. She also got 4 new doors and a new roof 2 days before the...
