DesertGoat's latest activity
-
Hello, Wanted to share my build with you all. It’s been a work in progress over the last few years and definitely a learning... -
Charging people to hang out and camp in a free location with little amenities to offset your fuel cost is strange to me
-
DesertGoat replied to the thread The Baja350 - a Dentside Story.you're talking about the bent filler plates, right? i agree - those need some better fits for the welds. When i take it apart to...
-
😂 -no caption needed
-
DesertGoat reacted to Pictafiedesign's post in the thread PICTAFIEDESIGN F150 Luxury Centermount Build with
Like.
Was able to smash a few things out this weekend. Got the front end together and made all skid plates. Milwaukee circular saw with a wood... -
DesertGoat reacted to Turboyota's post in the thread PICTAFIEDESIGN F150 Luxury Centermount Build with Like.
Those look really nice! The angled one forward of the fuel cell is a must-have. That area gets a surprising amount of gravel-blasting...
-
DesertGoat replied to the thread The Baja350 - a Dentside Story.Went to cycle the suspension with the tire on to plan for oil cooler clearances & discovered that the fender mounts were built...
-
-
Yes BUT it only works with the 1350 u-joint which would be a D50 inner axle/slip...
-
DesertGoat replied to the thread 1995 Ford F150 DD prelander.excuse me, an offset what now? is that also a solution for the D44 stuff on that inner axle joint that has to be ground out usually?
-
Ok got rear 3rd all regeared with 4.86 gears. Rpm is much better for all around driving with the 35s. 0 noise. Just drained the...
-
DesertGoat replied to the thread The Baja350 - a Dentside Story.pivoting off the radiator mount a little bit & working to get all the front body panels mounted so I can mock up all the front end...
-
-
Efforts continue - just about have both sides of the a pillar matched up and ready to install bumps on upper arm.
-
More progress on the front rebuild. New dash tubes and cab cage tie ins. Still working on an engine cage to frame tie in that I like...
-
DesertGoat replied to the thread The Baja350 - a Dentside Story.Making some progress on radiator mounting. Gonna have the homie come weld these out for me next week once i'm done with the mockups &...
-
-
Apparently, I never did a build thread for 2Ghetto on here. Maybe some day I can go find older build photos. But most people from DR...
