Brett_408's latest activity
-
I think he's back to begin moderation. now we just need Black Mac back. Doesyourshoequack or whatever his username was. -
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.Great info I did not know that. Possibly running a 12 point with a smaller head would solve that problem. Thanks for the insight
-
A few updates... My good buddy Robert Moruzzi hooked me up with a set of his valve covers for Christmas, to compliment the motor he...
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.You mean you have to pull the axle shaft completely out to pull the wheel off the hub? Wonder if the axle flange could be turned down to...
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.So I added everything up last night using a trail gear housing (3.5"x3/8" wall tubes), solid axle 14bolt floater kit, 35 spline flanged...
-
Brett_408 reacted to 95Bronco's post in the thread Rear End Full Floater Hubs? Options and Opinions with
Like.
Appreciate the price point as I've been thinking this is the way I'll be going. Been waiting for some kind of miracle used extended... -
Brett_408 reacted to RMC's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
Yes called the d609 by many. Solid cheap alternative
-
Brett_408 reacted to RMC's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
I do remember they were out of stock on bearings and yes rear snouts fit rear hubs once we located correct bearings from third party...
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.Does the 14 bolt hub fit the dana 60 spindle?
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.Thanks for all the insight. My last rear end build I had Burleson Design true the housing after all fabrication and welding was done.
-
Brett_408 reacted to RMC's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
You want the cheap route or the expensive route. I can advise both. Cheap route solid axle industries 5 on 5.5 rear hubs, snouts and...
-
Brett_408 reacted to Turboyota's post in the thread Rear End Full Floater Hubs? Options and Opinions with Like.
40 spline Schreiner! I have the 3.25”x.3125Wall tubes. After 7000 merciless miles I had to replace an axle seal, other than that, it’s...
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.Ron called me back yesterday actually $4024 for a complete fabricated rearend with 3.5" tubes and 40spline hubs, axles, rotors and...
-
Brett_408 replied to the thread Rear End Full Floater Hubs? Options and Opinions.I'm strongly thinking about that kit. Just worried about longevity with 37's on a 2" spindle.
-
Hi all, probably beating a dead horse with this topic but I'm going to piece a floater rear end together for my 94 bronco because my 8.8...
-
