Bpbuilt's latest activity
-
Getting really close to finally being done with the roll cage, just need to finish painting and put the interior back together. -
Used the trusty hi lift to take a 1/2” of preload out. Ride height looks tits now
-
Here is a bit more progress, mostly the beams getting closer to being done and starting to fit a truss on the old d60.
-
I like the you’re stocking up on diapers for less rr breaks for when you’re deep in a wrenching session.
-
I have a unique garage/shop setup especially for a house in the Bay Area. It's always been difficult to explain, I've always said that...
-
Bpbuilt reacted to Hambone's post in the thread Local Legend Not much left Tacoma left... 4500 koh build with
Like.
Company agreed to replace the radiator but said it would take roughly 2 weeks to make. I went ahead and added a baffle of my own to the... -
Bpbuilt reacted to Hambone's post in the thread Local Legend Not much left Tacoma left... 4500 koh build with Like.
I messed with it more today. Just idling it didn’t take more fluid. I tried lifting the rear with the engine hoist. Shaking the...
-
Bpbuilt reacted to Hambone's post in the thread Local Legend Not much left Tacoma left... 4500 koh build with Like.
Thermostat ordered. Drained the coolant today and caught almost all of it and didn’t make a mess so that was good. My dad and I got the...
-
Shes a runner. May lower the front a tad. List is getting really short; just have to change out the driveshaft u joint to a 1330, bleed...
-
bread and butter cnc mill from Taiwan. god bless them! 3 phase of fire up on the wall working great hi/low speed drill press area
-
9000# japan cnc that needs cash for electronics mechanical press brake of doom. 6 feet wide or 5 foot throat home built press frame
-
I was cleaning up after the last project, figured I'd grab a couple pics. Two bays are 32ft deep for the ability to put two cars in and...
-
Thou shalt not covet thine neighbors Jortz or Pan American tool shirt
-
There isn’t any room to do any sort of bracing on the left side of the crossmember with the 3rd and driveshaft installed. That right...
-
Ran into my first issue with the diff installed. Apparently I welded the back reinforcement plate in the wrong spot. It made sense to me...
