Recent content by BFR_Built 🇺🇸

Legend!!!!!

I am selling my welding/fixture table to get something bigger. This one is perfect for the small garage fabricator. $850 obo located in Wildomar CA.

I just applied some downward pressure using axle straps. I welded it in sections and then fully heated it after welding and wrapped in a blanket to cool slowly.

I did both.

I have had this tent for 2 years. It has never made it on to a vehicle. It’s basically new, with the exception of bumps and scratches from moving it around. One of the latches is bad, the ladder got tossed. $550 Firm or trade for anything cool. Tools or whatever. Located in Wildomar Ca.

How do you like it? I am looking at getting this table also.

5.3 Motor that I made some head plates for. These will be used to mount the engine into the rolling cart I made. The goal is to make it easy to replicate this build with other bodies. Motor and travs mocked up. I still have some adjustments to make.

A few cool rigs. I didn’t take many pics because we were hanging on the patio enjoy some ice cold drinks. There was around 40 trucks or so.

We are doing a little meet up after the rain. As the nights get longer we will do more. If you are free, you have something cool and you like tacos… come check it out.

I installed the Ruffstuff truss on the rear axle today. I used my heater on full to get the housing up to 400 ish degrees before welding it up. After I welded it up I put more heat to it and then wrapped it in a blanket. Should be good.

Yea, I bet they will. Really good prices and tons of parts. Tabs, heims and stuff. Very responsive on IG page.

Talley Metal Supply is the best. If you need steel give them a shot. Ordered via IG DM and delivered same day.

I had to put some wheels and tires on to see ride height.

Rear axle is on the cart. Adjustable from 105 to 120”. Adjustable pinion angle built into the jig.

I spent a little time get the front axle fixtured on my chassis cart. I built some new stand offs to get the ride height set for the cab.