Baconcreekmetal's latest activity
-
B1/2" pex cut down works as well. Common on fullsize ford trucks to go that route
-
BWorking on getting rid of some of the rattles. Three out of the four doors were missing these sleeves that only come with the entire...
-
Bhttps://www.instagram.com/p/DTV3sHTkt9j/?img_index=1&igsh=NjZiM2M3MzIxNA== So this is pretty exciting, got to say I didn’t think this...
-
BBaconcreekmetal replied to the thread 1973 F250 Prerunner Project.Those are really slick. I might need to build a set of those.
-
BThose are nice! Good work!
-
BIt anit much, but mobility achieved.
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with
Like.
6/29/2020: I just pinged Cho last night but with a little more pressure this time and he's going to have all my parts, beams +... -
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
PPA-CF is my intention. Has a temp resistance higher than what the reservoir bodies "should" get to. Seems worth trying. in other news...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
^mikey nailed it. The 350 single rates are just dinged up loaners from the homies at Accutune to figure out corner weight so we can...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
I basically just pieced together OnX trails since we threw this trip together in a bit of a rush. Parker : Signal (we had intended to go...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Between xmas & new years a couple of buddies decided to try this route... we started in palm desert and went through Joshua tree then...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Long time, no post. End of the year chaos. Painting & reassembly still in progress. Mocked up the ram assist cylinder for the first...
-
BI couldn't say on the design, we are following the plans from DIY offroad. I will say there are several vertical overlays on the front...
-
BI just noticed... but how come the center ribs in your breams are oriented parallel to the ground instead of vertically? Seems like...
-
BLets check in on this haha The front beams are all tacked together, we need to install them and cycle then we can weld them up. Vs ...