Baconcreekmetal's latest activity
-
BOh trust me. I’ve just dumped like $3k into my truck just doing maintenance repairs. Initially I took my truck into the repair shop just...
-
BOh I had a bad driver side seal. It had been like that for probably a year or so. I didn’t want to get into the mess of having to drop...
-
BWeird that you're getting that much rust on your ring gear/diff. You must had some kind of gasket or seal leak.
-
BI am determined to keep this 2” drop bracket kit alive hahah. These are essentially a replica of the factory ford stx brackets and...
-
BI’m probably gonna make you pick the doubler and store it at your junkyard until koh. 4 deez and sas is still on the horizon for this one.
-
B5 years no prep has caught up to this hoopty. I went to check wheel bearings, which resulted in me pulling wheels to do them. At that...
-
BIt was a prebent and prenotched kit. All those tubes where included. I don't think I would be able to accomplish that roof layout if i...
-
Bi missed it originally, or not and im forgetting/too lazy to look for my post, but the way you did the roof X over the driv./pass...
-
BLooking great! Love the tray. I need to do something similar. (y) for Cutlass OBS dome light. Just added mine too.
-
BUpdate: Got the bronco back on its weight and mostly put together. Test drive went good didn't have any hiccups. Few more small things...
-
BI sure hope so lol I'm tired of saying "it's soo close" lol
-
BDidn’t make it on the dyno today but still a very productive trip. Got it running and found problems with my sensor configuration that...
-
BUpdate this week didnt go as planned mainly as ive never cut and turned i forged beams before and definitely second guessing alot of...
-
BAlso did end up starting on the front by just tearing everything down and just a basic clean up still waiting on the pivot bushings to...
