Baconcreekmetal's latest activity
-
BIm 6'0" and my knees actually sit under the rear grab handle bar and behind the 2 on the B pillar. I was trying to kill 2 birds with one...
-
BMore "content"
-
BDone quite a bit since the last update. Working on this thing every night of the week for the last few weeks. Mounted the front seats...
-
BFun weekend in expo Chiva falls run with the family saturday morning. Got a good monsoon tuesday night so we were hoping there was...
-
BPersonally, if this were my truck, I'd just do a full tube chassis, center mount, etc. But its not financially feasible for him, the...
-
BYeah, figured I'd let the cat out of the bag early on.......Get everyone's hopes up, then string 'em along for however long until it...
-
BI figured I would get the thread started on this build seeing that its going to be more than a minor overhaul, and more along the lines...
-
BBaconcreekmetal reacted to Tree trunk's post in the thread The Baja350 - a Dentside Story with
Like.
I will :) The surface area of that tab on the intake tube might crack…. You might want to make it a little bit bigger…. -
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Despite me acknowledging that I'll make the tab bigger - does anybody else want to point out that the tab is going to crack? also, i...
-
BThe flexible joint you're looking for is the silicone coupler at the throttle body. If your motor is mounted on poly bushings, you won't...
-
BGo kart exhaust hanger.
-
BWrap a spring around it like an old two stroke pipe.
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Sorry but i'm not sure that's any better except you contact more area? in my eyes a hose clamp with a bracket & a tab with a bolt are...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Got my Walker Performance Filtration air cleaner in so I wanted to figure out the intake piping. Running out of space up here quickly...
-
BBaconcreekmetal reacted to DesertGoat's post in the thread The Baja350 - a Dentside Story with Like.
Bent tubes on the passenger side to get the lacing in. Still can't remove the header with these tubes. But maybe once I'm done modifying...