Baconcreekmetal's latest activity
-
BMore Eversen parts as payment for copying their back half 😄
-
Blove it. now hurry up and get the bedsides done. LOL
-
BHood and fenders finalized. Looks right
-
BMr.Stratton with the heaters
-
BSmall update. I got everything mocked up on the driver side, upper, lower, shock mounts, bump stops. Next up is extend axles, limit...
-
BAnd skinny 35’s will be in the future…
-
BI’m am stupid enough to do this much work and still run 33’s, you already knew that though lol I did the chamfer on them because it’s...
-
BSmall update, got the upper shock mounts figured out and was able to lean the coilover back a bit more. Every thing cycles much better...
-
BWell got a little more time today to get some more things done. Made some lower shock tabs which will get overlays, had moved the shock...
-
BYou can undo the clamp around the AC accumulator and kinda rotate it up underneath the cruise control module, and make a new bracket to...
-
BStarted mocking up the coilover which is a pretty tight fit with the spring on. Got it to were everything cleared and cycled ok but the...
-
BSo the factory upper ball joint has a pinch bolt that holds it in, I took a 3/4” bolt cut the head off and chucked it in the lathe to...
-
BNow on to the fun part, at this point I knew something needed to be done with the suspension, rear wasn’t bad all things considered but...
