Recent content by vcyota92

Also I installed a heat exchanger so I can make hot water showers from the lake. It worked extremely well

Rubicon was a success! Only issue was the carb was a little rich so I got about 1mpg.

tossed in some chromoly shafts in the front today. You can see they don’t neck down like the stock shafts. And a droop shot as I was getting ready to swap the lower coil springs

Stone canyon is now defense mine. You use to be able to go a lot further up the canyon with multiple dry waterfalls. It was a good run

I always loved going to this event as a kid! Such an awesome area to explore and I was lucky enough to run some of the good trails before they were closed like stone canyon, surprise canyon, and happy canyon

Don’t forget to add check high steer arms and those little bearings.

Can you wire up the e brakes independently and use them as cutting brakes?

fabbed up a fluids holder in the factory air vent hole that I had blocked off.

Grab handle fab’d up for the wife

Roof rack is ready to go. Someday I will build one that fits correctly but this isn’t to bad for a rack off my dads jeep that was free.99. I have a passanger grab handle to install and then it’s prep time for the rubicon. If I can find some spare cash, my plan is to add some air shocks in the...

Got the ice chest mount finished up. This will be for our upcoming rubicon run where I have to try and fit 4 days/3nights worth of 4 peoples stuff in this thing. I will be adding some foam to the cooler to act as a headrest for the kids too. I had to remove the ones on the seat for it to fit.

Make dimple dies great again

Should be a good time

In my opinion keep the stock weight. You have plenty of low gear with the doubler so the added mass isn’t really needed like it would be with a stock case setup.