Tree trunk's latest activity
-
Some glamour shots of the progress. -
Had this material laying around so we decided to use it as a firewall or as I would like to call it bullet proofing the front of the car.
-
Decided to make a skid plate for the front. I was able to bump form it on the press, not to shabby.
-
It's time to work on the engine before it goes in the frame for the last time (lies). Since I'm rotating the intake from factory I...
-
Designed this super intricate (not) fuel tank made out of 1/8 5052 aluminum, cut it on the laser and bent it on the bender. Lots of...
-
Time to move on to the fuel tank. Got this fuel pump setup from Radium. I chose it because it has 2 pumps, one lift pump and the second...
-
Installed the pedals in the correct location this time so that I could place the throttle pedal. Also installed the seats, forgot to...
-
Since I apparently have motivation to do sheet metal work I need to take advantage of the situation. Started making the inner floor...
-
3 hours later, no not really but it was time to move on. Now when the frame is welded it was time to start on the interior. Made this...
-
Today is a good day because today we get to weld the chassis but today is a long day because we needed to remove engine tranny and the...
-
I needed to finish the rear shock mounts to add some extra strength so I made these fancy straps from some scrap material laying around...
-
Mounted the radiator with some angle aluminum that I welded to the radiator and made 2 brackets that will be welded to the frame. Bought...
-
Went ape shit and made a metric fuck ton of tubes. Turns out making straight tubes is easier than rolling and adding shit ton of bends...
-
Time for spare tire mount fab. Made these threaded bungs on the lathe drilled perfectly straight holes and made cross bars that the...
-
Great build thread. Cool fab, good jokes, and big sexy German dudes.
