Motiracer38's latest activity
-
Motiracer38 replied to the thread Sequoia Family Crawler.Mine is real similar and I tried other outputs but the speedo only reacts to the test on out2. Does the raw frequency show up on the... -
Motiracer38 replied to the thread Sequoia Family Crawler.Does the Suzuki power it with 12v? I have the Y-R sensor output wired to signal in and output 2 calibrated (oc). Set to low-low and...
-
Motiracer38 replied to the thread Sequoia Family Crawler.Dang, I was hoping you were onto something. Best thing about being wrong is you know what to fix.
-
Motiracer38 replied to the thread Sequoia Family Crawler.Mine is a 2003 with ABS. The 2wd output had two speed sensors, a two wire which pins to SP2- and SP2+ on the ECU and a three wire which...
-
Motiracer38 replied to the thread Sequoia Family Crawler.Yesterday was a big day, I was able get this thing assembled enough for a test drive out of the garage and around the neighborhood. By...
-
-
Motiracer38 replied to the thread 2025 OFFROAD EXPO OCT 4-5, OC FAIR GROUNDS...No Mikey or Bruce? What better do they have to do that weekend?
-
Motiracer38 replied to the thread V8 Solid Axle Ranger.That's a ton more clearance. Did you ever get the assist ram in there?
-
Motiracer38 replied to the thread Sequoia Family Crawler.Looking through my notes, it's a 99-02 Chevy 2500HD with a bore of 37mm which is 1.45in It has 1/2-20 outlets that I put a Banjo bolt...
-
Motiracer38 replied to the thread 2025 OFFROAD EXPO OCT 4-5, OC FAIR GROUNDS...I was looking into motels down that way as well for me and the two younger boys for the whole weekend but school is throwing a wrench...
-
Motiracer38 replied to the thread 3D Print Chat.I tried printing ABS for the first time last weekend and it failed miserably. It was also old filament that had been sitting out for...
-
-
Motiracer38 replied to the thread 3D Print Chat.Bodj recently asked about printing PETG and I have struggled bigly for quite awhile before finally figuring it out. The biggest issue is...
-
-
Motiracer38 replied to the thread Sequoia Family Crawler.I pulled my hair out quite a bit over wet PETG. Report to the 3D printing thread and I'll explain more.
-
Motiracer38 replied to the thread Pissnoma.That's right, I forgot about the radius arms. Sounds like it'll work great until the bushing start to wear out.
-
Motiracer38 replied to the thread Rusty Red.My LS400 1UZ had two triggers that would add resistance and reduce voltage. I wired it to full kill and haven't noticed any difference...
-
Motiracer38 replied to the thread Sequoia Family Crawler.This was the second design and one hole is till off a bit but entirely usable. I used PETG same as. Switch panel used in the jeep for a...
