Motiracer38's latest activity
-
Motiracer38 replied to the thread Sequoia Family Crawler.The Expo was a blast, both my boys loved running around and checking out all the trucks. They led a pack that I'm sure annoyed quite a... -
-
Motiracer38 replied to the thread Local Legend Project: Tur-BRO-yota.Great to see it running again, just in time for desert season
-
Motiracer38 replied to the thread ***Panamint Valley Days 2025***.Jail Canyon sounds like the promise of a good time. I wish I had this weekend free.
-
Motiracer38 replied to the thread 3D Print Chat.Bronco is all finished up. Asked Rodin the AI politely to model a bronco based off a Fiberwerx picture, scaled to fit on Cura slicer...
-
-
Motiracer38 replied to the thread Fire Pit Recommendations/Thoughts.I was half planning on building a deployable base for one of these and run a remote hose...
-
Motiracer38 replied to the thread 2025 OFFROAD EXPO OCT 4-5, OC FAIR GROUNDS...I'll have my truck and only two boys so a couple open seats for you. Even have a room booked at the same motel. We're bringing BMX bikes...
-
-
Motiracer38 replied to the thread FrankenTRD - Stock -> 37's on IFS -> Full Widths.That's an ambitious project, can't wait to see updates. What supercharger adapter parts are you using? I was looking into the Elate...
-
Motiracer38 replied to the thread school me on short course setups.It helps if you have a lot of weight to cut down on the harshness. Full cage, dual spares, crew cab, etc. Still much better than leaves...
-
Motiracer38 replied to the thread 2025 OFFROAD EXPO OCT 4-5, OC FAIR GROUNDS...The Pacific Airshow will be happening centered around the Huntington Pier on Saturday from 10-4:30. Being that's about 6 miles away we...
-
Motiracer38 replied to the thread 3D Print Chat.Inspired by the AI model thread I took a photo from fiberwerx website, cleaned it up a bit with Gemini, and used Rodin to create a 3d...
-
-
Motiracer38 replied to the thread Sequoia Family Crawler.Mine's a bit tighter, 1.75 to the block and using every bit of it for up travel. I was real surprised that even with the rear sump it...
-
Motiracer38 replied to the thread Sequoia Family Crawler.Dang, that would have been useful
-
Motiracer38 replied to the thread Sequoia Family Crawler.Mine is real similar and I tried other outputs but the speedo only reacts to the test on out2. Does the raw frequency show up on the...
-
Motiracer38 replied to the thread Sequoia Family Crawler.Does the Suzuki power it with 12v? I have the Y-R sensor output wired to signal in and output 2 calibrated (oc). Set to low-low and...
