Recent content by GahnRacing

You still are 84projectford.. you old bitch

2.9L/M5OD swap ain’t lookin’ too bad now, ey?…

Sick MS Paint skills

I’m gonna drag my nuts across it

Bump. Price drop, $1800.

@SaltyMethods is actually @Partybarge_pilot change my mind.

I slang Coke in any weather. Fiend’s gonna fiend

I’m always wet…

I always liked this thread. Spotted this in Visalia last week.

I kind of wish they were 18’s. They’re a 16 3.5 5 tube. Got them for the price of one new one. Not a terrible deal I believe 🤷🏻‍♂️.

Added a couple goodies to the shelf.

When you do a cut and turn on the entire end, where’s your preferred cut?

Much better than it has been. I took the time to play with some different speeds, pierce delay, lead ins/outs, and a new set of consumables. I was able to knock the small amount of slag off with a putty knife. Cuts 3/16ths nicely!

I done kept on keepin on. Just very slowly. My house finally sold so I’m 100% back at daddy’s house living rent free. Designed seat mounts Cut seat mounts