Recent content by Down For Mobbing

I am doing some upgrades on my truck and have removed the following parts off and are now for sale! Equal length beams, Dana 44 hubs with stange8 locking kit, James Way Off-Road hub covers, dual swing steering, radius arms, brakes, rotors and swingers. radius arms and swingers are a mix of MIG...

SOLD

I have 5 17" 4.5"BS 6x5.5 method bedrock wheels drilled for 5/8 studs for sale. asking $1200 I can bring them to KOH if needed. located in the San Diego area.

Most of you have probably already seen this if you follow me on instagram but got the toyota all put together with some new raceline monster wheels and painted bedsides.

I learned when it was too late that I have toyota front calipers and they dont clear some wheels. I swapped to method wheel and due to the design of the wheel they did not clear my toyota front calipers and had to switch back to racelines. The rear is wilwood calipers. Has custom built spindles...

Our New Years Johnson Valley Camp Out is Jan 2nd-4th. Not an event just the off-road community chasing dirt miles and celebrating the new year together in one big camp. Huge thanks to @desert.dime and @socalcowboy_ for putting this together with us. @socalcowboy_ will be hosting line dancing...

Toyota peeps! Anyone have wheel to caliper clearance problems? The calipers make contact with the method wheels on the front. Anyone run into this problem? Seems like that is why the truck came with 4.5 backspace wheels.

Rad truck and super clean!

Do you have a link to them? Didn't see them on eBay just found "axle pros" I was just looking at these from Napa https://www.napaonline.com/en/p/NCV941733?srsltid=AfmBOopLfMpjtsp7EVHgeW13qtEAHHBUiYeeb6_NDuvcItL7bKfXAPBN To be honest the rabbit hole you can go down with these trucks is crazy...

talked with Yotamasters about what parts I have and what I still need. They said getting the right outer CV can be hard so sometimes it is easier to buy a whole new CV. Looks like I will contact zippsub9 for some CV for this truck. Thanks for sharing his info! These are the parts needed to...

To be honest I am still trying to figure what I have for the 4wd. The truck came with most the parts to do the manual hub conversion. I will update here when I get more info. I know I still need hub stud kit, aisin locking hub, genuine toyota wheel bearing nut and a special socket PN W1272 I am...

Having two prerunners might sound cool but I can officially confirm it’s a whole new level of stress. At one point, both trucks were in piles of parts across the garage. Definitely a humbling experience lol. Now that the Ranger is back together, I’ve been able to shift my focus back to the...

Found some photos from the last time the truck was used.

You're 100% right! It came with a new compressor and was told the condenser is was new. Need to find someone to make a custom high and low side. I've been spending a few minutes a day hitting tubes with scotch brite here and there. luckily it all seems to just be surface rust. Something I tried...